Sharp DM-4551 DM-3551 DM-4551 Operation Manual Suite - Page 12

NORMAL COPYING 7 Select the desired output mode (see below). 2-SIDED COPY OUTPUT The sort mode is the default mode. To select the group mode, touch the [OUTPUT] key, then touch the [GROUP] key on the output setting screen, and then touch the [OK] key on the setting screen. 8 Use the numeric keys to set the desired number of copies. Up to 999 can be set. Use the [C] (clear) key to cancel an entry if a mistake has been made. 9 Press the [START] key. If the [C] key is pressed while originals are being scanned, scanning will stop. If copying had already started, copying and scanning will stop after the original in progress is output to the original exit area. In these cases the copy quantity will be reset to "0". If scanning has been completed but copying is still in progress, copying will continue. NOTE The 1-sided to 1-sided copying mode is set as the default in the initial settings. This setting can be changed by a key operator program (initial status setting ). Output modes (sort mode and group mode) [Example] Five sets of copies from three originals G Sort copy Originals Five sets of copies When originals are placed in the document feeder tray, a sort icon will appear on the touch panel and the sort copy mode will be automatically selected. In this case, copies will be delivered as shown in the upper illustration to the left. For output in the group mode as shown in the lower left illustration, the group mode must be selected on the output setting screen. G Group copy Originals 10 Five copies of each original