Sharp DM-4551 DM-3551 DM-4551 Operation Manual Suite - Page 15

NORMAL COPYING 4 Select the desired output mode (see below). 2-SIDED COPY OUTPUT When a document is detected on the document glass, the group mode will be automatically selected. To select sort copy, touch the [OUTPUT] key, then touch the [SORT] key on the displayed screen, and then touch the [OK] key. NOTE If you touch the [SORT] or [GROUP] key, its corresponding icon will appear on the touch panel. To change the selection, touch the icon to return the display to the output setting screen. 5 Use the numeric keys to set the desired number of copies. Up to 999 can be set. Use the [C] (clear) key to cancel an entry if a mistake has been made. 6 Press the [START] key. Replace the original with the next original and press the [START] key. Repeat this operation until all originals have been scanned. If sort was selected in step 4, go to the next step. 7 Touch the [READ-END] key. PLACE NEXT ORIGINAL. PRESS [START]. WHEN FINISHED, PRESS [READ-END]. READ-END Output mode (sort copy and group copy) [Example] Five sets of copies from three originals G Sort copy Originals G Group copy Five sets of copies When originals are placed in the document feeder tray, a sort icon will appear on the touch panel and the sort copy mode will be automatically selected. In this case, copies will be delivered as shown in the upper illustration to the left. For output in the group mode as shown in the lower left illustration, the group mode must be selected on the output setting screen. Originals Five copies of each original 13