Sharp DM-4551 DM-3551 DM-4551 Operation Manual Suite - Page 188

LOADING PAPER The message "ADD PAPER" or "OPEN TRAY Follow the procedure below to load paper. AND ADD PAPER" will appear when paper runs out during operation. NOTES q Do not use curled or folded paper. Doing so may cause a misfeed. q For best results use paper supplied by SHARP. (See page 1-18.) q When you change the paper type and size in paper tray 1, set the paper type and size referring to "Setting the paper size and type" (page 1-19). q Do not place heavy objects or press hard on any tray which is pulled out. Loading paper in paper tray 1 1 Pull out paper tray 1. Gently pull the tray out until it stops. 2 Load paper into the tray. Do not load paper above the maximum height line (approximately 500 sheets of 20 lbs. (80 g/m2) paper). 3 Gently push tray 1 into the machine. Push the tray firmly all the way into the machine. 4 Set the paper type. If you change the paper type, be sure to set the paper type referring to "Setting the paper size and type" (page 1-19). 5 Loading paper in paper tray 1 is now complete. Changing the paper size in paper tray 1 For paper tray 1, 8-1/2" x 11", A4 or B5 size paper can be set. Use the following procedure to change the size as needed. 1 Pull out paper tray 1. 4 Gently push tray 1 into the machine. If paper remains in the tray, remove it. Push the tray firmly all the way into the machine. 2 Adjust the guide plates A and B in the tray to the length and width of the paper. The guide plates A and B are slidable. Adjust them to the paper size to be loaded while squeezing their lock levers. 3 Load paper into the tray. 5 Set the paper size. Be sure to set the paper size and paper type referring to "Setting the paper size and type" (page 1-19). If this is not done, paper misfeeds will occur. 6 Changing paper size in paper tray 1 is now complete. 1-16