Sharp DM-4551 DM-3551 DM-4551 Operation Manual Suite - Page 35

Setting programs This section describes the setting of programs common to copier, facsimile and network scanning features. For programs dedicated to facsimile, network scanning and programs common to both the copier and printer features, see their respective manuals. Copy function settings The following programs can be set in "Copy function settings". G Initial status settings G Exposure adjustment G Rotation copy setting G Auto paper selection setting G 600dpi x 600dpi scanning mode G Quick scan from document glass KEY OPERATOR PROGRAMS Initial status settings The copier settings will be reset when the main switch is turned off, when the [CA] key is pressed or when the auto clear interval has elapsed. Use this program to establish new initial settings or to return the initial settings to the factory default settings. Paper tray, exposure mode, copy ratio, duplex mode, and output mode default settings can be made. NOTE If a duplex mode other than 1-sided to 1-sided is set as the default and either the duplex or scanner mode is disabled*, the default will change to the 1-sided to 1-sided mode. * Disable duplex unit (page 10 of the Key Operator's Guide) * Disabling of document feeder (page 34) Exposure adjustment Use this program to lighten or darken copies in the automatic exposure mode.The factory setting is "5". "1" indicates lighter density and "9" indicates darker density on the touch panel. Rotation copy setting If this program is set, the image of originals will rotate when the orientation of the originals does not match that of the copy paper. (Rotation copy will function only if the auto paper select or auto image mode has been selected.) NOTE For copying from 5-1/2 x 8-1/2 or A5 size originals onto 51/2 x 8-1/2R or A5R paper, this program must be set. Auto paper selection setting Use this program to set the paper type* for the auto paper select mode to "Plain paper" or "Plain paper and recycle paper". * Paper type specified in Tray setting of the custom setting function (page 1-20 of "Operation manual (for printer operation and general information)") 600dpi x 600dpi scanning mode Use this program to change the original scanning resolution of the automatic document feeder from 600 x 300 dpi to 600 x 600 dpi. If this mode is set, the copy quality for fine characters and fine lines will be improved but the original scanning speed will be slower. NOTE If the original scanning speed is more important than higher resolution, do not set this program. Quick scan from document glass Use this program to change the original scanning resolution on the document glass from 600 x 600dpi to 600 x 300 dpi. If you set this program, the first copy time will be shorter but the copy image will become a little more coarse. NOTE If the copy image quality is more important than first copy time, do not set this program. 33