Sharp DM-4551 DM-3551 DM-4551 Operation Manual Suite - Page 258

SADDLE STITCH FINISHER Using the saddle stitch finisher s Selecting staple or saddle stitch from the printer driver. Select "Properties" on the printer driver setting screen and open the "Main" tab shown in the illustration to the right. For normal edge or corner stapling, select "Left", "Right" or "Top" under Binding Edge and "1 Staple" or "2 Staples" under "Staple". For saddle stitch selection, check the radio button of "Pamphlet Style" under the Document Style heading, then select "Tiled Pamphlet" or "2-Up pamphlet". Then select "2 Staples" in the "Staple" drop down under the "Finishing" heading. s Selecting hole punching Open the "Main" tab and check "Punch" under the "Finishing" heading. The illustration below shows the screen for a PCL printer driver in the Windows 98 environment as an example. NOTES q The settings screens above will appear only if the devices have been set properly in the printer driver configuration (see NOTE on page 2-5). q The combination of paper selection and other functions may not be compatible. For instance, if heavy paper, envelopes, label stock, etc. are selected, it will not be possible to select duplex, offset tray, saddle stitch, etc. For details, see printer driver help. s Using the finisher functions in the copy mode When [OUTPUT] is selected on the copy mode basic screen, a screen for making selections for sort, group, staple, punch and exit tray will appear. OUTPUT SORT STAPLE SORT GROUP OFFSET TRAY OFFSET OK CENTER TRAY SADDLE STITCH PUNCH [GROUP] key (See page 5-18.) When Group is selected, all copies of the same original will be grouped. [STAPLE SORT] key (See page 5-19.) When Staple Sort is selected, sorted sets will be stapled and delivered to the offset tray. (They will not be not offset stacked.) [SORT] key (See page 5-18.) When Sort is selected, sets of copies will be sequentially delivered. 5-20 Icon display An icon representing a selected function (sort, staple sort or group) is displayed. [OFFSET TRAY] key (See page 5-17.) If Offset is checked, the offset will be enabled. If not checked, the offset will not function. If the staple sort is selected, the check mark of offset will be automatically canceled. [CENTER TRAY] key If the center tray is selected, output paper will be delivered to the exit tray located above the main unit.