Yamaha 01V96i Reference Manual - Page 19

Input Channels Setting the Input Channels from the Display 19 • MIX This parameter sets the mix balance of dry (Input Channel) and wet (delayed) signals. • FB.GAIN This parameter sets the amount of delay feedback. Tip: • This function is unavailable for the ST IN Channels. • The delay time range depends on the sampling rate at which the 01V96i is operating. • If you select the DELAY SCALE meter or feet button, the dis- tance value can be converted to the delay time based on sonic speeds (about 343.59 m/sec at 20 degrees Celsius). This option is useful if you wish to correct the timing difference between two sound sources that are far apart. • If you select the DELAY SCALE beat button, a parameter box for setting a note that represents the beat and a parameter box for a tempo (BPM) setting appear below the DELAY SCALE parameter. Setting the note and BPM settings in these parameter boxes enables you to set a delay time that synchronizes to the song tempo. Gating Input Channels To set the Input Channel gates, use the [SEL] buttons to select the desired Input Channel, then press the DISPLAY ACCESS [DYNAMICS] button, then press the [F1] button. The Dynamics | Gate Edit page appears. 1 2 3 45 2 STEREO LINK This parameter's ON/OFF button enables you to pair gates for stereo operation even when the Input Channels are not paired. 3 CURVE This area displays the current gate curve. 4 TYPE This area displays the current gate type (GATE or DUCKING). Note: You cannot change the gate type on this page. To change the gate type, recall a program that uses the desired gate type from the Gate library. 5 Meters These meters indicate the levels of the post-gate signals and the amount of gain reduction. 6 ON/OFF The ON/OFF button turns the currently-selected Input Channel's gate on or off. 7 PARAMETER These controls enable you to set the gate parameters. (See page 148 for more information on the parameters.) Tip: • This function is unavailable for the ST IN Channels. • You can store the gate settings in the Gate library, which features preset programs that can be used for various applications (see page 79). 6 7 1 KEYIN SOURCE Select one of the following buttons to determine the trigger source for the currently-selected Input Channel's gate. • SELF The selected channel's own input signal is the trigger source. • CHANNEL Another Channel's input signal is the trigger source. Select the desired channel in the parameter box below the CHANNEL button. • AUX An Aux Send signal is the trigger source. Select the desired bus in the parameter box below the AUX button. 01V96i-Reference Manual