Yamaha 01V96i Reference Manual - Page 22
Panning Input Channels, Press the DISPLAY ACCESS [PAN/ROUTING] - reset
View all Yamaha 01V96i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
22 Input Channels Panning Input Channels Input Channels can be panned in the range of L63 through CENTER to R63. To pan each channel, press the [PAN/ROUTING] button repeatedly until the Pan/Route | Pan page appears. 1 2 Move the cursor to the desired Pan control, then rotate the Parameter wheel to set the value. 1 Pan controls These knobs adjust the channel pan settings. Press the [ENTER] button to reset the currently-selected Pan control to center. 2 MODE The MODE parameter determines how paired Input Channels are panned. There are three Pan modes as follows: • INDIVIDUAL In Individual mode, paired Input Channel pan controls operate independently. • GANG In Gang mode, paired Input Channel pan controls operate in unison, maintaining the current pan range. • INV GANG In Inverse Gang mode, paired Input Channel pan controls operate in unison but move in opposite directions. Tip: • You can adjust the pan setting for the ST IN Channels L/R sep- arately. • You can also adjust the pan setting for the Input Channels using the PAN control in the SELECTED CHANNEL section. • Surround Pan is available when the 01V96i is in Surround mode. See page 52 for more information on Surround Pan. Routing Input Channels You can route each Input Channel to the Stereo Bus, Bus 1-8, or its own Direct Out. With the default setting, signals are routed only to the Stereo Bus. However, you can patch signals to a single or multiple destinations, if necessary. 1. Press the DISPLAY ACCESS [PAN/ROUTING] button repeatedly until the page listed below that contains the desired channels appears. • ROUT1-16 page This page enables you to change the routing for Input Channels 1-16. • ROUT17-ST1 page This page enables you to change the routing for Input Channels 17-32 and ST IN Channels 1-4. The parameters on these two pages (and the procedure for setting them) are the same. 5 67 1 2 3 4 8 1 PAN buttons These buttons determine whether the channel's Pan setting is applied to the Bus outs. In surround mode, they also determine whether the Surround Pan setting is applied to the Bus Outs. 2 Bus buttons 1-8 These buttons route the currently-selected Input Channel to the Bus Outs. If the 01V96i is in Surround mode, the button indicators change as follows, depending on the selected Surround mode: Bus buttons 12345678 Surround mode: 3-1 L R C S 5 6 7 8 Surround mode: 5.1 L R Ls Rs C E 7 8 Surround mode: 6.1 L R Ls Rs C Bs E 8 L=Left, R=Right, C=Center, S=Surround, Ls=Left Surround Rs=Right Surround, E=Low Frequency Effect, Bs=Back Surround The above table shows the default assignment. The actual assignment may vary, depending on the settings on the DIO/Setup | Surround Bus Setup page. 01V96i-Reference Manual