Yamaha 01V96i Reference Manual - Page 49

Monitoring Monitoring 49 Monitoring This chapter explains how to set up monitoring and use the Solo function on the 01V96i. Monitor The 01V96i features the stereo signal path to feed the monitors. The monitoring signal source is patched to MONITOR OUT connectors L & R and the PHONES connector. The following diagram illustrates the monitoring signal flow. Monitor and Solo Setup For monitoring and solo setup, press the DISPLAY ACCESS [DIO/SETUP] button repeatedly until the DIO/Setup | Monitor page appears. 5 16 2 3 4 STEREO L STEREO R SOLO L SOLO R MONO SOLO L SOLO R SOLO TRIM BUS1-8 AUX1-8 OUTPUT SOLO 8 8 L [2TR IN] RCA R SOLO LOGIC MONITOR TRIM DA DA MONITOR MONITOR OUT /2TR IN LEVEL PHONES LEVEL L [MONITOR OUT] R [PHONES] • SOLO bus This special bus routes soloed Input Channels to the Monitor outputs, bypassing Bus 1-8 and the Stereo Bus. • OUTPUT SOLO This section routes soloed Output Channels (Aux Out 1-8, Bus Out 1-8) to the Monitor outputs. Note: Input and Output Channels cannot be solo-monitored simultaneously. The solo function for the most-recently soloed channels is enabled. • MONITOR TRIM This section adjusts the monitoring signal level in the digital domain. • MONITOR OUT LEVEL Use the MONITOR [MONITOR OUT] control on the top panel to adjust the monitoring signal level in the analog domain. • MONITOR/2TR IN As a monitoring signal, you can select either the 01V96i internal signals or 2TR IN digital inputs. • PHONES The Monitor signal is also fed to the PHONES jack. You can set the level independently. 7 8 9 This page contains the following parameters: 1 SOLO This parameter turns the Solo function on or off. By default, it is set to Enabled. 2 MODE This parameter determines how the Solo function works. There are two options. The setting affects only Input Channels. • RECORDING In Recording Solo mode, soloed Input Channel signals are fed to the Solo bus and output via the Monitor outputs. Other buses (Stereo bus and Bus 1-8) are unaffected by this mode. • MIXDOWN In Mixdown Solo mode, soloed Input Channel signals are fed to the Stereo bus and output via the Monitor outputs. Unsoloed Input Channels are not fed to the Stereo bus while the Solo function is enabled. Tip: • Recording Solo mode is convenient when you wish to mon- itor certain Input Channels while recording, since the Stereo bus and Bus 1-8 signals are unaffected. • Mixdown Solo mode is useful when you wish to mute unsoloed Input Channels and feed soloed Input Channel signals to the Stereo bus during mixdown. 01V96i-Reference Manual