ZyXEL NetAtlas User Guide - Page 174

Chapter 14 Switch Configuration The following table describes the labels in this screen. Table 84 Switch Configuration > Link Aggregation TABLE DESCRIPTION Enable Link Aggregation Select the check box to activate link aggregation. LACP Priority LACP system priority is a number between 1 and 65,535. The switch with the lowest system priority (and lowest port number if system priority is the same) becomes the LACP "server". The LACP "server" controls the operation of LACP setup. Enter a number to set the priority of an active port using Link Aggregate Control Protocol (LACP). The smaller the number, the higher the priority level. Group ID The field identifies the link aggregation group, that is, one logical link containing multiple ports Active Select this option to activate a trunk group. Dynamic (LACP) Select this check box to enable Dynamic LACP. Port This field displays the Ethernet port number. Group Select the trunk group to which the port belongs. LACP Timeout Timeout is the time interval between the individual port exchanges of LACP packets in order to check that the peer port in the trunk group is still up. If a port does not respond after three tries, then it is deemed to be "down" and is removed from the trunk. Set a short timeout (one second) for busy trunked links to ensure that disabled ports are removed from the trunk group as soon as possible. Select either 1 second or 30 seconds. Apply Click Apply to save your changes. Copy to... Click the Copy to.. button to copy the configuration from the device that you are currently configuring to other device(s) of the same model. Close Click Close to exit this screen. 174 NetAtlas EPON Manager User's Guide