D-Link DGS-3324SR Product Manual - Page 123

xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch User Manual Parameters Profile ID Description This is the identifier number for this profile set. Mode Select Permit to specify that the packets that match the access profile are forwarded by the Switch, according to any additional rule added (see below). Select Deny to specify that packets that match the access profile are not forwarded by the Switch and will be filtered. Select Mirror to specify that packets that match the access profile are mirrored to a port defined in the Port Mirroring window. Port Mirroring must be enabled and a target port must be set. Remember, Port Mirroring cannot cross-box, that is they cannot span across switches in a switch stack. Access ID Type in a unique identifier number for this access. This value can be set from 1 - 65535. • Auto Assign - Checking this field will instruct the Switch to automatically assign an Access ID for the rule being created. Type Selected profile based on Ethernet (MAC Address), IP address, Packet Content Mask or IPv6. • Ethernet instructs the Switch to examine the layer 2 part of each packet header. • IP instructs the Switch to examine the IP address in each frame's header. • Packet Content Mask instructs the Switch to examine the packet header. • IPv6 instructs the Switch to examine the IPv6 part of each packet header. Priority (0-7) This parameter is specified to re-write the 802.1p default priority previously set in the Switch, which is used to determine the CoS queue to which packets are forwarded to. Once this field is specified, packets accepted by the Switch that match this priority are forwarded to the CoS queue specified previously by the user. Replace priority with − Click the corresponding box to re-write the 802.1p default priority of a packet to the value entered in the Priority field, which meets the criteria specified previously in this command, before forwarding it on to the specified CoS queue. Otherwise, a packet will have its incoming 802.1p user priority re-written to its original value before being forwarded by the Switch. For more information on priority queues, CoS queues and mapping for 802.1p, see the QoS section of this manual. Replace DSCP (0- Select this option to instruct the Switch to replace the DSCP value (in a packet that meets 63) the selected criteria) with the value entered in the adjacent field. VLAN Name Allows the entry of a name for a previously configured VLAN. Source MAC Source MAC Address - Enter a MAC Address for the source MAC address. Destination MAC Destination MAC Address - Enter a MAC Address mask for the destination MAC address. 802.1p (0-7) Enter a value from 0-7 to specify that the access profile will apply only to packets with this 802.1p priority value. Ethernet Type Specifies that the access profile will apply only to packets with this hexadecimal 802.1Q Ethernet type value (hex 0x0-0xffff) in the packet header. The Ethernet type value may be set in the form: hex 0x0-0xffff, which means the user may choose any combination of letters and numbers ranging from a-f and from 0-9999. Port The Access Rule may be configured on a per-port basis by entering the port number of the switch in the switch stack into this field When a range of ports is to be configured the 108