D-Link DGS-3324SR Product Manual - Page 124
Auto Assign, Access ID, Access Rule Display window Ethernet
UPC - 790069262067
View all D-Link DGS-3324SR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 124 highlights
xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch User Manual the switch in the switch stack into this field. When a range of ports is to be configured, the Auto Assign check box MUST be clicked in the Access ID field of this window. If not, the user will be presented with an error message and the access rule will not be configured. The port list is specified by listing the lowest switch number and the beginning port number on that switch, separated by a colon. Then the highest switch number, and the highest port number of the range (also separated by a colon) are specified. The beginning and end of the port list range are separated by a dash. For example, 1:3 specifies switch number 1, port 3. 2:4 specifies switch number 2, port 4. 1:3 - 2:4 specifies all of the ports between switch 1, port 3 and switch 2, port 4 − in numerical order. Entering all will denote all ports on the Switch. To view the settings of a previously correctly configured rule, click in the Access Rule Table to view the following screen: Figure 6- 65. Access Rule Display window (Ethernet) NOTE: When using the ACL Mirror function, ensure that the Port Mirroring function is enabled and a target mirror port is set. In the Configuration folder, click the Access Profile Table link opening the Access Profile Table. Under the heading Access Rule, clicking Modify, will open the following window. Figure 6- 66. Access Rule Table window - IP To create a new rule set for an access profile click the Add button. A new window is displayed. To remove a previously created rule, click the corresponding button. 109