D-Link DGS-3324SR Product Manual - Page 197

xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch User Manual Parameter Interface Name Description Displays the of an IP interface previously configured on the Switch. Area ID Allows the entry of an OSPF Area ID configured above. Router Priority (0255) Allows the entry of a number between 0 and 255 representing the OSPF priority of the selected area. If a Router Priority of 0 is selected, the Switch cannot be elected as the Designated Router for the network. Hello Interval (165535) Allows the specification of the interval between the transmission of OSPF Hello packets, in seconds. Between 1 and 65535 seconds can be specified. The Hello Interval, Dead Interval, Authorization Type, and Authorization Key should be the same for all routers on the same network. Dead Interval (165535) Allows the specification of the length of time between the receipt of Hello packets from a neighbor router before the selected area declares that router down. An interval between 1 and 65535 seconds can be specified. The Dead Interval must be evenly divisible by the Hello Interval. State Allows the OSPF interface to be disabled for the selected area without changing the configuration for that area. Auth Type This field can be toggled between None, Simple, and MD5 using the space bar. This allows a choice of authorization schemes for OSPF packets that may be exchanged over the OSPF routing domain. • None specifies no authorization. • Simple uses a simple password to determine if the packets are from an authorized OSPF router. When Simple is selected, the Auth Key field allows the entry of an 8-character password that must be the same as a password configured on a neighbor OSPF router. • MD5 uses a cryptographic key entered in the MD5 Key Table Configuration menu. When MD5 is selected, the Auth Key ID field allows the specification of the Key ID as defined in the MD5 configuration above. This must be the same MD5 Key as used by the neighboring router. Password/Auth. Key Enter a Key ID of up to 5 characters to set the Auth. Key ID for either the Simple Auth ID Type or the MD5 Auth Type, as specified in the previous parameter. Metric (1-65535) This field allows the entry of a number between 1 and 65,535 that is representative of the OSPF cost of reaching the selected OSPF interface. The default metric is 1. DR State A read-only field describing the Designated Router state of the IP interface. This field many read DR if the interface is the designated router, or Backup DR if the interface is the Backup Designated Router. The highest IP address will be the Designated Router and is determined by the OSPF Hello Protocol of the Switch. DR Address The IP address of the aforementioned Designated Router. Backup DR Address The IP address of the aforementioned Backup Designated Router. Transmit Delay A read-only field that denotes the estimated time to transmit a Link State Update Packet over this interface, in seconds. Retransmit Time A read-only field that denotes the time between LSA retransmissions over this interface, in seconds. 182