D-Link DGS-3324SR Product Manual - Page 130

xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch User Manual Figure 6- 72. Access Profile Table (IPv6) To remove a previously created rule, select it and click the button. To add a new Access Rule, click the Add button: Figure 6- 73. Access Rule Configuration - IPv6 To set the Access Rule for the Packet Content Mask, adjust the following parameters and click Apply. Parameter Profile ID Description This is the identifier number for this profile set. Mode Select Permit to specify that the packets that match the access profile are forwarded by the Switch, according to any additional rule added (see below). Select Deny to specify that packets that match the access profile are not forwarded by the Switch and will be filtered. Select Mirror to specify that packets that match the access profile are mirrored to a port defined in the Port Mirroring window. Port Mirroring must be enabled and a target port must be set. Remember, Port Mirroring cannot cross-box, that is they cannot span across switches in a switch stack. Access ID Type in a unique identifier number for this access. This value can be set from 1 65535. • Auto Assign - Checking this field will instruct the Switch to automatically assign an Access ID for the rule being created. Type Selected profile based on Ethernet (MAC Address), IP address, Packet Content Mask or IPv6. • Ethernet instructs the Switch to examine the layer 2 part of each packet header. • IP instructs the Switch to examine the IP address in each frame's header. 115