D-Link DGS-3324SR Product Manual - Page 140

xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch User Manual Parameters Profile ID Mode Access ID Type VLAN Name Source MAC Destination MAC 802.1p (0-7) Ethernet Type Description This is the identifier number for this profile set. Select Permit to specify that the packets that match the access profile are forwarded by the Switch, according to any additional rule added (see below). Select Deny to specify that packets that match the access profile are not forwarded by the Switch and will be filtered. Type in a unique identifier number for this access and priority. This value can be set from 1 - 5. Selected profile based on Ethernet (MAC Address), IP address, Packet Content or IPv6. • Ethernet instructs the Switch to examine the layer 2 part of each packet header. • IP instructs the Switch to examine the IP address in each frame's header. • Packet Content Mask instructs the Switch to examine the packet header. • IPv6 instructs the Switch to examine the IPv6 part of each packet header. Allows the entry of a name for a previously configured VLAN. Source MAC Address - Enter a MAC Address for the source MAC address. Destination MAC Address - Enter a MAC Address mask for the destination MAC address. Enter a value from 0-7 to specify that the access profile will apply only to packets with this 802.1p priority value. Specifies that the access profile will apply only to packets with this hexadecimal 802.1Q Ethernet type value (hex 0x0-0xffff) in the packet header. The Ethernet type value may be set in the form: hex 0x0-0xffff, which means the user may choose any combination of letters and numbers ranging from a-f and from 0-9999. To view the settings of a previously correctly configured rule, click following screen: in the CPU Access Rule Table to view the Figure 6- 83. CPU Access Rule Display (Ethernet). The following window is the CPU Access Rule Table for IP. 125