Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 110
permit
View all Dell Force10 MXL Blade manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 110 highlights
www.dell.com | support.dell.com permit Configure a filter to pass IP packets meeting the filter criteria. Syntax permit {ip | ip-protocol-number} {source mask | any | host ip-address} {destination mask | any | host ip-address} [count [byte] [dscp value] [order] [fragments] Parameters To remove this filter, you have two choices: • Use the no seq sequence-number command if you know the filter's sequence number. • Use the no deny {ip | ip-protocol-number} {source mask | any | host ip-address} {destination mask | any | host ip-address} command. ip ip-protocol-number source mask any host ip-address destination count byte dscp order fragments Enter the keyword ip to configure a generic IP access list. The keyword ip specifies that the access list will permit all IP protocols. Enter a number from 0 to 255 to permit based on the protocol identified in the IP protocol header. Range: 0 to 128 Enter the IP address of the network or host from which the packets were sent. Enter a network mask in /prefix format (/x) or A.B.C.D. The mask, when specified in A.B.C.D format, may be either contiguous or non-contiguous. Enter the keyword any to specify that all routes are subject to the filter. Enter the keyword host followed by the IP address to specify a host IP address. Enter the IP address of the network or host to which the packets are sent. (OPTIONAL) Enter the keyword count to count packets processed by the filter. (OPTIONAL) Enter the keyword byte to count bytes processed by the filter. (OPTIONAL) Enter the keyword dscp to match to the IP DSCP values. (OPTIONAL) Enter the keyword order to specify the QoS order of priority for the ACL entry. Range: 0-254 (where 0 is the highest priority and 254 is the lowest; lower order numbers have a higher priority) Default: If the order keyword is not used, the ACLs have the lowest order by default (255). Enter the keyword fragments to use ACLs to control packet fragments. Defaults Not configured. Command Modes CONFIGURATION-IP ACCESS-LIST-EXTENDED Command History Usage Information Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module The order option is relevant in the context of the Policy QoS feature only. For more information, refer to the Quality of Service (QoS) chapter of the FTOS Configuration Guide. In the MXL Switch, you can configure either count (packets) or count (bytes). However, for an ACL with multiple rules, you can configure some ACLs with count (packets) and others as count (bytes) at any given time 110 | Access Control Lists (ACL)