Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 660
vlan-stack dot1p-mapping, vlan-stack protocol-type, show vlan
View all Dell Force10 MXL Blade manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 660 highlights
www.dell.com | support.dell.com Figure 37-3. show vlan Command Example with Stackable VLANs FTOS#show vlan Codes: * - Default VLAN, G - GVRP VLANs NUM * 1 2 3 4 5 FTOS# Status Inactive Active Active Active Active Q Ports M Te 13/13 M Te 13/0-2 M Po1(Te 13/14-15) M Te 13/18 M Te 13/3 M Po1(Te 13/14-15) M Te 13/18 M Te 13/4 M Po1(Te 13/14-15) M Te 13/18 M Te 13/5 vlan-stack dot1p-mapping Map C-Tag dot1p values to a S-Tag dot1p value. C-Tag values may be separated by commas and dashed ranges are permitted. Dynamic Mode CoS overrides any Layer 2 QoS configuration in case of conflicts. Syntax vlan-stack dot1p-mapping c-tag-dot1p values sp-tag-dot1p value Parameters c-tag-dot1p value sp-tag-dot1p value Enter the keyword followed by the customer dot1p value that will be mapped to a service provider do1p value. Range: 0 to 5 Enter the keyword followed by the service provider dot1p value. Range: 0 to 5 Defaults none Command Modes INTERFACE Command History Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module vlan-stack protocol-type Define the Stackable VLAN tag protocol identifier (TPID) for the outer VLAN tag (also called the VMAN tag). If you do not configure this command, FTOS assigns the value 0x9100. Syntax vlan-stack protocol-type number Parameters number Enter the hexadecimal number as the Stackable VLAN tag. You may specify both bytes of the 2-byte S-Tag TPID. Range: 0 to FFFF Default: 9100 Defaults 0x9100 660 | VLAN Stacking