Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 305
ip unreachables, management route
View all Dell Force10 MXL Blade manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 305 highlights
Defaults Enabled. Command Modes CONFIGURATION Command History Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module ip unreachables Enable the generation of Internet Control Message Protocol (ICMP) unreachable messages. Syntax ip unreachables To disable the generation of ICMP messages, use the no ip unreachables command. Defaults Disabled Command Modes INTERFACE Command History Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module management route Configure a static route that points to the Management interface or a forwarding router. Syntax management route {ipv4-address}/mask {forwarding-router-address | managementethernet} Parameters {ipv4-address}/mask forwarding-router-address managementethernet Enter an IPv4 address (A.B.C.D) followed by the prefix-length for the IP address of the management interface. Enter an IPv4 address of a forwarding router. Enter the keyword managementethernet for the Management interface. Defaults Not configured. Command Modes CONFIGURATION Command History Usage Information Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module When a static route (or a protocol route) overlaps with Management static route, the static route (or a protocol route) is preferred over the Management Static route. Also, Management static routes and the Management Connected prefix are not reflected in the hardware routing tables. Separate routing tables are maintained for IPv4 management routes. This command manages both tables. Related Commands interface ManagementEthernet Configures the Management port on the system. IPv4 Routing | 305