Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 605
Storm Control, Overview, Commands, Important Points to Remember
View all Dell Force10 MXL Blade manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 605 highlights
32 Storm Control Overview The Dell Force10 operating software (FTOS) storm control feature allows users to limit or suppress traffic during a traffic storm. Commands The storm control commands are: • show storm-control broadcast • show storm-control multicast • show storm-control unknown-unicast • storm-control broadcast (Configuration) • storm-control broadcast (Interface) • storm-control multicast (Configuration) • storm-control multicast (Interface) • storm-control unknown-unicast (Configuration) • storm-control unknown-unicast (Interface) Important Points to Remember • You can only apply interface commands on physical interfaces (virtual local area networks [VLANs] and link aggregation group [LAG] interfaces are not supported). • An INTERFACE-level command only supports storm control configuration on ingress. • An INTERFACE-level command overrides any CONFIGURATION-level ingress command for that physical interface, if both are configured. • Do not apply per-VLAN quality of service (QoS) on an interface that has storm control enabled (either on an interface or globally). show storm-control broadcast Display the storm control broadcast configuration. Syntax show storm-control broadcast [interface] Storm Control | 605