Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 164

www.dell.com | support.dell.com Command History Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module description Enter a text description of the DCB policy (PFC input or ETS output). Syntax description text To remove the text description, use the no description command. Parameters text Enter the description of the output policy. Maximum: 32 characters. Defaults none Command Modes DCB INPUT POLICY DCB OUTPUT POLICY Command History Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module Related Commands dcb-input dcb-policy input dcb-output dcb-policy output Create a DCB PFC input policy. Apply the output policy. Create a DCBETS output policy. Apply the output policy. ets mode on Enable the ETS configuration so that scheduling and bandwidth allocation configured in an ETS output policy or received in a DCBX TLV from a peer can take effect on an interface. Syntax ets mode on To remove the ETS configuration, use the ets mode on command. Defaults ETS mode is on. Command Modes DCB OUTPUT POLICY Command History Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module Usage Information If you disable ETS in an output policy applied to an interface using the no ets mode on command, any previously configured QoS settings at the interface or global level take effect. If QoS settings are configured at the interface or global level and in an output policy map (service-policy output command), the QoS configuration in the output policy takes precedence. 164 | Data Center Bridging