Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 243
interface Command Example
View all Dell Force10 MXL Blade manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 243 highlights
Related Commands show running-config show interfaces Displays the flow configuration parameters (non-default values only). Display information on a specific physical interface or virtual interface. interface Configure a physical interface on the switch. Syntax interface interface Parameters interface Enter one of the following keywords and slot/port or number information: • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE followed by the slot/port information. Defaults Not configured. Command Modes CONFIGURATION Command History Example Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module Figure 14-7. interface Command Example FTOS(conf)#interface tengig 0/0 FTOS(conf-if-tengig-0/0)#exit# Usage Information You cannot delete a physical interface. By default, physical interfaces are disabled (shutdown) and are in Layer 3 mode. To place an interface in mode, ensure that the interface's configuration does not contain an IP address and enter the Port Channel Commands command. Related Commands interface loopback interface null interface port-channel interface vlan show interfaces Configures a Loopback interface. Configures a Null interface. Configures a port channel. Configures a VLAN. Displays interface configuration. Interfaces | 243