Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 94
Common IP ACL Commands
View all Dell Force10 MXL Blade manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 94 highlights
www.dell.com | support.dell.com Parameters prefix-list-name StartingSeqNum Step-to-Increment Enter the name of configured prefix list, up to 140 characters long. Enter the starting sequence number to resequence. Range: 0 to 65535 Enter the step to increment the sequence number. Range: 1 to 65535 Defaults none Command Modes EXEC EXEC Privilege Command History Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module Usage When all sequence numbers have been exhausted, this feature permits re-assigning new sequence Information numbers to entries of an existing prefix list. Related Commands seq Assign a sequence number to a deny or permit filter in an IP access list while creating the filter. show config Display the current ACL configuration. Syntax show config Command Modes CONFIGURATION-IP ACCESS-LIST-STANDARD CONFIGURATION-IP ACCESS-LIST-EXTENDED CONFIGURATION-MAC ACCESS LIST-STANDARD CONFIGURATION-MAC ACCESS LIST-EXTENDED Command History Example Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module Figure 6-2. show config Command Example FTOS(conf-ext-nacl)#show conf ! ip access-list extended patches FTOS(conf-ext-nacl)# Common IP ACL Commands The following commands are available within both IP ACL modes (Standard and Extended) and do not have mode-specific options. When an access-list (ACL) is created without any rule and then applied to an interface, ACL behavior reflects an implicit permit. The MXL 10/40GbE Switch IO Module platform supports both ingress and egress IP ACLs. 94 | Access Control Lists (ACL)