Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 500
output-delay
View all Dell Force10 MXL Blade manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 500 highlights
www.dell.com | support.dell.com Parameters prefix-list-name offset interface Enter the name of an established Prefix list to determine which incoming routes will be modified. Enter a number from zero (0) to 16 to be applied to the incoming route metric matching the access list specified. If you set an offset value to zero (0), no action is taken. (OPTIONAL) Enter the following keywords and slot/port or number information: • For a Port Channel interface, enter the keyword port-channel followed by a number: Range: 1-128 • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE followed by the slot/port information. • For a VLAN, enter the keyword vlan followed by a number from 1 to 4094. Defaults Not configured. Command Modes ROUTER RIP Command History Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module Usage Information When the offset metric is applied to an interface, that value takes precedence over an offset value that is not extended to an interface. Related Commands ip prefix-list Enters PREFIX-LIST mode and configures a prefix list. output-delay Set the interpacket delay of successive packets to the same neighbor. Syntax output-delay delay To return to the switch software defaults for interpacket delay, use the no output-delay command. Parameters delay Specify a number of milliseconds as the delay interval. Range: 8 to 50 Default Command Modes Not configured. ROUTER RIP Command History Usage Information Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module This command is intended for low-speed interfaces. 500 | Routing Information Protocol (RIP)