Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 19
PREFIX-LIST Mode, SPANNING TREE Mode, Per-VLAN SPANNING TREE Plus Mode, Spanning, Tree Protocol STP
View all Dell Force10 MXL Blade manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
PREFIX-LIST Mode While in CONFIGURATION mode, use the ip prefix-list command to enter PREFIX-LIST mode and configure a prefix list. To enter PREFIX-LIST mode: 1. Verify that you are logged in to CONFIGURATION mode. 2. Enter the ip prefix-list command. You must include a name for the prefix list. The prompt changes to include (conf-nprefixl). You can return to CONFIGURATION mode by use the exit command. SPANNING TREE Mode Use STP mode to enable and configure the spanning tree protocol (STP), as described in Spanning Tree Protocol (STP). To enter STP mode: 1. Verify that you are logged into CONFIGURATION mode. 2. Enter the protocol spanning-tree 0 command. You can return to CONFIGURATION mode by using the exit command. Per-VLAN SPANNING TREE Plus Mode Use PVST+ mode to enable and configure the per-VLAN spanning tree (PVST+) protocol, as described in Per-VLAN Spanning Tree Plus (PVST+). Note: The protocol is PVST+, but the plus sign is dropped at the CLI prompt. To enter PVST+ mode: 1. Verify that you are logged into CONFIGURATION mode. 2. Enter the protocol spanning-tree pvst command. You can return to CONFIGURATION mode by using the exit command. RAPID SPANNING TREE Mode Use RSTP mode to enable and configure the rapid spanning tree protocol (RSTP), as described in Rapid Spanning Tree Protocol (RSTP). To enter RSTP mode: 1. Verify that you are logged into CONFIGURATION mode. 2. Enter the protocol spanning-tree rstp command. You can return to CONFIGURATION mode by using the exit command. CLI Basics | 19