Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 579
Simple Network Management Protocol (SNMP) and Syslog, Overview, SNMP Commands
View all Dell Force10 MXL Blade manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 579 highlights
Simple Network Management Protocol (SNMP) and Syslog Overview This chapter contains commands to configure and monitor the simple network management protocol (SNMP) v1/v2/v3 and Syslog. The chapter contains the following sections: • SNMP Commands • Syslog Commands SNMP Commands The SNMP commands available in the Dell Force10 operating software (FTOS) are: • show snmp • show snmp engineID • show snmp group • show snmp user • snmp ifmib ifalias long • snmp-server community • snmp-server contact • snmp-server enable traps • snmp-server engineID • snmp-server group • snmp-server host • snmp-server location • snmp-server packetsize • snmp-server trap-source • snmp-server user • snmp-server view • snmp trap link-status The SNMP is used to communicate management information between the network management stations and the agents in the network elements. FTOS supports SNMP versions 1, 2c, and 3, supporting both read-only and read-write modes. FTOS sends SNMP traps, which are messages informing an SNMP management system about the network. FTOS supports up to 16 SNMP trap receivers. Simple Network Management Protocol (SNMP) and Syslog | 579