Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 647
description, downstream, description Command Example
View all Dell Force10 MXL Blade manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 647 highlights
description Enter a text description of an uplink-state group. Syntax description text Parameters text Text description of the uplink-state group. Maximum length: 80 alphanumeric characters. Defaults none Command Modes UPLINK-STATE-GROUP Command History Related Commands Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module uplink-state-group Creates an uplink-state group and enable the tracking of upstream links. Example Figure 36-1. description Command Example FTOS(conf-uplink-state-group-3)#description Testing UFD feature FTOS(conf-uplink-state-group-3)#show config ! uplink-state-group 3 description Testing UFD feature downstream Assign a port or port-channel to the uplink-state group as a downstream interface. Syntax downstream interface To delete a downstream interface, use the no downstream interface command. Parameters interface Enter one of the following interface types: 10-Gigabit Ethernet: tengigabitethernet {slot/port | slot/port-range} 40-Gigabit Ethernet: fortygigabitethernet {slot/port |slot/port-range} Port channel: port-channel {1-512 | port-channel-range} Where port-range and port-channel-range specify a range of ports separated by a dash (-) and/or individual ports/port channels in any order; for example: tengigabitethernet 1/1-2,5,9,11-12 port-channel 1-3,5 A comma is required to separate each port and port-range entry. Defaults none Command Modes UPLINK-STATE-GROUP Command History Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module Uplink Failure Detection (UFD) | 647