Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 408

www.dell.com | support.dell.com show ip ospf Display information on the OSPF process configured on the switch. Syntax show ip ospf process-id Parameters process-id Enter the OSPF Process ID to show a specific process. If no Process ID is entered, command applies only to the first OSPF process. Command Modes EXEC EXEC Privilege Command History Usage Information Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module If you delete all the network area commands for Area 0, the show ip ospf command output will not list Area 0. Example Figure 21-5. show ip ospf process-id Command Example FTOS#show ip ospf 10 Routing Process ospf 10 with ID 1.1.1.1 Virtual router default-vrf Supports only single TOS (TOS0) routes SPF schedule delay 5 secs, Hold time between two SPFs 10 secs Convergence Level 0 Min LSA origination 0 msec, Min LSA arrival 1000 msec Min LSA hold time 5000 msec, Max LSA wait time 5000 msec Number of area in this router is 1, normal 1 stub 0 nssa 0 Area BACKBONE (0) Number of interface in this area is 1 SPF algorithm executed 205 times Area ranges are FTOS# Table 21-2. show ip ospf process-id Command Descriptions: Line Beginning with "Routing Process..." "Supports only..." "SPF schedule..." "Convergence Level" "Min LSA...." "Number of..." Description Displays the OSPF process ID and the IP address associated with the process ID. Displays the number of Type of Service (TOS) rouse supported. Displays the delay and hold time configured for this process ID. Displays the intervals set for LSA transmission and acceptance. Displays the number and type of areas configured for this process ID. Related Commands show ip ospf database show ip ospf interface show ip ospf neighbor Displays information about the OSPF routes configured. Displays the OSPF interfaces configured. Displays the OSPF neighbors configured. 408 | Open Shortest Path First (OSPFv2)