Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 602

www.dell.com | support.dell.com all limit number-of-buffers Enter the keyword all to turn off all Enter the keyword limit followed by the number of buffers to be queued for the terminal after which new messages are dropped Range: 20 to 300 Default: 20 Defaults Disabled. If enabled without level or number-of-buffers options specified, level = 2 and number-of-buffers = 20 are the defaults. Command Modes LINE Command History Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module Usage When you enable logging synchronous , unsolicited messages appear between software prompts and Information outputs. Only the messages with a severity at or below the set level are sent to the console. If the message queue limit is reached on a terminal line and messages are discarded, a system message appears on that terminal line. Messages may continue to appear on other terminal lines. Related Commands logging on Enables logging. logging trap Specify which messages are logged to the Syslog server based the message severity. Syntax logging trap [level] To return to the default values, use the default logging trap command. To disable logging, use the no logging trap command. Parameters level Indicate a value from 0 to 7 or enter one of the following parameters: emergencies, alerts, critical, errors, warnings, notifications, informational, or debugging. The default is 6. Defaults 6 or informational. Command Modes CONFIGURATION Command History Related Commands Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module logging logging on Enables the logging to another device. Enables logging. 602 | Simple Network Management Protocol (SNMP) and Syslog