Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 521
disable, forward-delay
View all Dell Force10 MXL Blade manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 521 highlights
Parameters description Enter a description to identify the Rapid Spanning Tree (80 characters maximum). Defaults none Command Modes SPANNING TREE (The prompt is "config-rstp".) Command History Related Commands Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module protocol spanning-tree rstp Enters SPANNING TREE mode on the switch. disable Disable RSTP globally on the system. Syntax disable To enable rapid spanning tree protocol, use the no disable command. Defaults RSTP is disabled Command Modes CONFIGURATION RSTP (conf-rstp) Command History Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module Related Commands protocol spanning-tree rstp Enters Rapid Spanning Tree mode forward-delay Configure the amount of time the interface waits in the Listening State and the Learning State before transitioning to the Forwarding State. Syntax forward-delay seconds To return to the default setting, use the no forward-delay command. Parameters seconds Enter the number of seconds that FTOS waits before transitioning RSTP to the forwarding state. Range: 4 to 30 Default: 15 seconds Defaults 15 seconds Command Modes CONFIGURATION RSTP (conf-rstp) Command History Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module Rapid Spanning Tree Protocol (RSTP) | 521