Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 498
ip split-horizon, maximum-paths, neighbor
View all Dell Force10 MXL Blade manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 498 highlights
www.dell.com | support.dell.com Related Commands ip rip receive version version Sets the RIP version for the interface to receive traffic. Sets the RIP version to be used for the switch software. ip split-horizon Enable split-horizon for RIP data on the interface. As described in RFC 2453, the split-horizon scheme prevents any routes learned over a specific interface to be sent back out that interface. Syntax ip split-horizon To disable split-horizon, enter no ip split-horizon. Defaults Enabled Command Modes INTERFACE Command History Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module Related Commands ip poison-reverse Sets the prefix for RIP routing updates. maximum-paths Set RIP to forward packets over multiple paths. Syntax maximum-paths number To return to the default values, use the no maximum-paths command. Parameters number Enter the number of paths. Range: 1 to 16. The default is 4 paths. Defaults 4 Command Modes ROUTER RIP Command History Usage Information Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module RIP supports a maximum of 16 ECMP paths. neighbor Define a neighbor router with which to exchange RIP information. Syntax neighbor ip-address To delete a neighbor setting, use the no neighbor ip-address command. 498 | Routing Information Protocol (RIP)