Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 648
Usage, Information, Related, Commands, Syntax, no downstream auto-recover, Defaults, Command Modes
View all Dell Force10 MXL Blade manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 648 highlights
www.dell.com | support.dell.com Usage Information You can assign physical port or port-channel interfaces to an uplink-state group. You can assign an interface to only one uplink-state group. You must configure each interface assigned to an uplink-state group as either an upstream or downstream interface, but not both. You can assign individual member ports of a port channel to the group. An uplink-state group can contain either the member ports of a port channel or the port channel itself, but not both. Related Commands downstream upstream uplink-state-group Assigns a port or port-channel to the uplink-state group as a downstream interface. Assigns a port or port-channel to the uplink-state group as an upstream interface. Creates an uplink-state group and enable the tracking of upstream links. downstream auto-recover Enable auto-recovery so that UFD-disabled downstream ports in an uplink-state group automatically come up when a disabled upstream port in the group comes back up. Syntax downstream auto-recover To disable auto-recovery on downstream links, use the no downstream auto-recover command. Defaults The auto-recovery of UFD-disabled downstream ports is enabled. Command Modes UPLINK-STATE-GROUP Command History Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module Related Commands downstream upstream uplink-state-group Assigns a port or port-channel to the uplink-state group as a downstream interface. Assigns a port or port-channel to the uplink-state group as an upstream interface. Creates an uplink-state group and enable the tracking of upstream links. downstream disable links Configure the number of downstream links in the uplink-state group that are disabled if one upstream link in an uplink-state group goes down. Syntax downstream disable links {number | all} To revert to the default setting, use the no downstream disable links command. Parameters number all Enter the number of downstream links to be brought down by UFD. Range: 1 to 1024. Brings down all downstream links in the group. Defaults All Command Modes UPLINK-STATE-GROUP 648 | Uplink Failure Detection (UFD)