Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 167
pfc no-drop queues, pfc priority, dot1p Value in the Incoming Frame, Egress Queue Assignment
View all Dell Force10 MXL Blade manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 167 highlights
pfc no-drop queues Configure the port queues that will still function as no-drop queues for lossless traffic. Syntax pfc no-drop queues queue-range To remove the no-drop port queues, use the no pfc no-drop queues command. Parameters queue-range Enter the queue range. Separate the queue values with a comma; specify a priority range with a dash; for example, pfc no-drop queues 1,3 or pfc no-drop queues 2-3. Valid values: 0 to 3. Defaults No lossless queues are configured. Command Modes INTERFACE Command History Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module Usage Information The maximum number of lossless queues globally supported on the switch is two. Table 9-1 lists the dot1p priority-queue assignments. Table 9-1. dot1p Priority-Queue Assignments dot1p Value in the Incoming Frame 0 1 2 3 4 5 6 7 Egress Queue Assignment 0 0 0 1 2 3 3 3 pfc priority Configure the CoS traffic to be stopped for the specified delay. Syntax pfc priority priority-range To delete the pfc priority configuration, use the no pfc priority command. Parameters priority-range Enter the 802.1p values of the frames to be paused. Separate the priority values with a comma; specify a priority range with a dash; for example, pfc priority 1,3,5-7. Valued values: 0 to 7. Data Center Bridging | 167