Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 576

www.dell.com | support.dell.com Related Commands sflow sample-rate (Interface) Changes the Interface sampling rate. sflow sample-rate (Interface) Change the Interface default sampling rate. Syntax sflow sample-rate value To return to the default sampling rate, use the no sflow sample-rate command. Parameters value Enter the sampling rate value. Range:256 to 8388608 packets Enter values in powers of 2 only, for example 4096, 8192, 16384 etc. Default: 32768 packets Defaults The global default sampling Command Modes CONFIGURATION Command History Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module Usage Information This command changes the sampling rate for an interface. By default, the sampling rate of an interface is set to the same value as the current global default sampling rate. If the value entered is not a correct power of 2, the command generates an error message with the previous and next power-of-2 value. Select one of these two number and re-enter the command. Related Commands sflow sample-rate (Global) Changes the sampling rate globally. show sflow Display the current sFlow configuration Syntax show sflow [interface] Parameters interface (OPTIONAL) Enter the following keywords and slot/port or number information: • For a 40-Gigabit Ethernet interface, enter the keyword FortyGigabitEthernet followed by the slot/port information. • For a Loopback interface, enter the keyword loopback followed by a number from 0 to 16383. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. Command Modes EXEC EXEC Privilege 576 | sFlow