Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 359
disable, hello
View all Dell Force10 MXL Blade manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 359 highlights
disable Enable or disable LLDP. Syntax disable To enable LLDP, use the no disable Defaults Enabled, that is no disable Command Modes CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp) Command History Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module Related Commands protocol lldp (Configuration) debug lldp interface show lldp neighbors show running-config lldp Enables LLDP globally. Debugs LLDP Displays the LLDP neighbors Displays the LLDP running configuration hello Configure the rate at which the LLDP control packets are sent to its peer. Syntax hello seconds To revert to the default, use the no hello seconds command. Parameters seconds Enter the rate, in seconds, at which the control packets are sent to its peer. Rate: 5 to 180 seconds Default: 30 seconds Defaults 30 seconds Command Modes CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp) Command History Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module mode Set LLDP to receive or transmit. Syntax mode {tx | rx} To return to the default, use the no mode {tx | rx} command. Parameters tx rx Enter the keyword tx to set the mode to transmit. Enter the keyword rx to set the mode to receive. Defaults Both transmit and receive Link Layer Discovery Protocol (LLDP) | 359