Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 258
rate-interval, show config, show config from INTERFACE RANGE mode
View all Dell Force10 MXL Blade manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 258 highlights
www.dell.com | support.dell.com rate-interval Configure the traffic sampling interval on the selected interface. Syntax rate-interval seconds Parameters seconds Enter the number of seconds for which to collect traffic data. Range: 5 to 299 seconds Note: For 0-5 seconds, polling occurs every 5 seconds. For 6-10 seconds, polling occurs every 10 seconds. For any other value, polling occurs every 15 seconds. Defaults 299 seconds Command Modes INTERFACE Command History Usage Information Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module The configured rate interval is displayed, along with the collected traffic data, in the output of show interfaces commands. Related Commands show interfaces Displays information on physical and virtual interfaces. show config Display the interface configuration. Syntax show config Command Modes INTERFACE Command History Example Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module Figure 14-26. show config Command Example for the INTERFACE Mode FTOS(conf-if)#show conf ! interface TenGigabitEthernet 1/7 no ip address switchport no shutdown FTOS(conf-if)# show config (from INTERFACE RANGE mode) Display the bulk configured interfaces (interface range). Syntax show config Command Modes CONFIGURATION INTERFACE (conf-if-range) 258 | Interfaces