Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 116
Not con d, CONFIGURATION-IP ACCESS-LIST-EXTENDED, Defaults, Command Modes, Command, History
View all Dell Force10 MXL Blade manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 116 highlights
www.dell.com | support.dell.com ip tcp udp source mask any host ip-address operator port port destination message-type count byte dscp order fragments Enter the keyword ip to configure a generic IP access list. The keyword ip specifies that the access list will permit all IP protocols. Enter the keyword tcp to configure a TCP access list filter. Enter the keyword udp to configure a UDP access list filter. Enter the IP address of the network or host from which the packets were sent. Enter a network mask in /prefix format (/x) or A.B.C.D. The mask, when specified in A.B.C.D format, may be either contiguous or non-contiguous. Enter the keyword any to specify that all routes are subject to the filter. Enter the keyword host followed by the IP address to specify a host IP address. (OPTIONAL) Enter one of the following logical operands: • eq = equal to • neq = not equal to • gt = greater than • lt = less than • range = inclusive range of ports (you must specify two ports for the port parameter.) (OPTIONAL) Enter the application layer port number. Enter two port numbers if using the range logical operand. Range: 0 to 65535 The following list includes some common TCP port numbers: • 23 = Telnet • 20 and 21 = FTP • 25 = SMTP • 169 = SNMP Enter the IP address of the network or host to which the packets are sent. (OPTIONAL) Enter an ICMP message type, either with the type (and code, if necessary) numbers or with the name of the message type (ICMP message types are listed in Table 6-2). Range: 0 to 255 for ICMP type; 0 to 255 for ICMP code (OPTIONAL) Enter the keyword count to count packets processed by the filter. (OPTIONAL) Enter the keyword byte to count bytes processed by the filter. (OPTIONAL) Enter the keyword dscp to match to the IP DSCP values. (OPTIONAL) Enter the keyword order to specify the QoS priority for the ACL entry. Range: 0-254 (where 0 is the highest priority and 254 is the lowest; lower order numbers have a higher priority) Default: If the order keyword is not used, the ACLs have the lowest order by default (255). Enter the keyword fragments to use ACLs to control packet fragments. Defaults Not configured Command Modes CONFIGURATION-IP ACCESS-LIST-EXTENDED Command History Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module 116 | Access Control Lists (ACL)