Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 245
interface null Command Example
View all Dell Force10 MXL Blade manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 245 highlights
The Management port is enabled by default (no shutdown). Use the ip address command to assign an IP address to the Management port. Related Commands management route duplex (1000/10000 Interfaces) Configure a static route that points to the Management interface or a forwarding router. Configure duplex mode on any physical interfaces where the speed is set to 1000/10000 interface null Configure a Null interface on the switch. Syntax interface null number Parameters number Enter zero (0) as the Null interface number. Defaults Not configured; number = 0 Command Modes CONFIGURATION Command History Example Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module Figure 14-10. interface null Command Example FTOS(conf)#interface null 0 FTOS(conf-if-nu-0)# Usage You cannot delete the Null interface. The only configuration command possible in a Null interface is ip Information unreachables. Related Commands interface interface loopback interface port-channel interface vlan ip unreachables Configures a physical interface. Configures a Loopback interface. Configures a port channel. Configures a VLAN. Enables generation of ICMP unreachable messages. interface range This command permits configuration of a range of interfaces to which subsequent commands are applied (bulk configuration). Using the interface range command, you can enter identical commands for a range of interface. Syntax interface range interface, interface,... Interfaces | 245