Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 495

distance Assign a weight (for prioritization) to all routes in the RIP routing table or to a specific route. Lower weights ("administrative distance") are preferred. Syntax distance weight [ip-address mask [prefix-name]] To return to the default values, use the no distance weight [ip-address mask] command. Parameters weight ip-address mask prefix-name Enter a number from 1 to 255 for the weight (for prioritization). The default is 120. (OPTIONAL) Enter the IP address, in dotted decimal format (A.B.C.D), of the host or network to receive the new distance metric. If you enter an IP address, you must also enter a mask for that IP address, in either dotted decimal format or /prefix format (/x) (OPTIONAL) Enter a configured prefix list name. Defaults weight = 120 Command Modes ROUTER RIP Command History Related Commands Version 8.3.16.1 default-metric Introduced on MXL 10/40GbE Switch IO Module Assigns one distance metric to all routes learned using the redistribute command. distribute-list in Configure a filter for incoming routing updates. Syntax distribute-list prefix-list-name in [interface] To delete the filter, use the no distribute-list prefix-list-name in command. Parameters prefix-list-name interface Enter the name of a configured prefix list. (OPTIONAL) Identifies the interface type slot/port as one of the following: • For a Port Channel interface, enter the keyword port-channel followed by a number: Range: 1-128 • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE followed by the slot/port information. • For a VLAN, enter the keyword vlan followed by a number from 1 to 4094. Defaults Not configured. Command Modes ROUTER RIP Command History Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module Routing Information Protocol (RIP) | 495