Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 609
storm-control multicast Interface, storm-control unknown-unicast Configuration
View all Dell Force10 MXL Blade manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 609 highlights
Usage Information Broadcast traffic (all 0xFs) should be counted against broadcast storm control meter, not against the multicast storm control meter. It is possible, however, that some multicast control traffic may get dropped when storm control thresholds are exceeded. storm-control multicast (Interface) Configure the packets per second of multicast traffic allowed on a MXL Switch interface (ingress only). Syntax storm-control multicast [packets_per_second] in To disable multicast storm control on the interface, use the no storm-control multicast [packets_per_second] in command. Parameters packets_per_second Enter the packets per second of broadcast traffic allowed from the network. Range: 0 to 33554368 Defaults none Command Modes INTERFACE (conf-if-interface-slot/port) Command History Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module storm-control unknown-unicast (Configuration) Configure the packets per second of unknown-unicast traffic allowed on a MXL Switch (ingress rate only). Syntax storm-control unknown-unicast [packets_per_second] in To disable storm control for unknown-unicast traffic, use the no storm-control unknown-unicast [packets_per_second] in command. Parameters packets_per_second Enter the packets per second of broadcast traffic allowed from the network. Range: 0 to 33554368 Defaults none Command Modes CONFIGURATION Command History Usage Information Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module Unknown Unicast Storm-Control is valid for Layer 2 and Layer 2/Layer 3 interfaces. Storm Control | 609