Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 572
Commands
View all Dell Force10 MXL Blade manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 572 highlights
www.dell.com | support.dell.com Commands The sFlow commands are: • sflow collector • sflow enable (Global) • sflow enable (Interface) • sflow extended-switch enable • sflow polling-interval (Global) • sflow polling-interval (Interface) • sflow sample-rate (Global) • sflow sample-rate (Interface) • show sflow • show sflow stack-unit sflow collector Configure a collector device to which sFlow datagrams are forwarded. Syntax sflow collector {ipv4-address} agent-addr {ipv4-address} [number [max-datagram-size number]] | [max-datagram-size number] To delete a configured collector, use the no sflow collector {ipv4-address} agent-addr {ipv4-address} [number [max-datagram-size number]] | [max-datagram-size number] command. Parameters sflow collector ipv4-address agent-addr ipv4-address number max-datagram-size number Enter the IPv4 (A.B.C.D) of the sFlow collector device. Enter the IPv4 (A.B.C.D) of the sFlow agent in the router. (OPTIONAL) Enter the UDP port number (User Datagram Protocol). Range: 0 to 65535 Default: 6343 (OPTIONAL) Enter the keyword max-datagram-size followed by the size number in bytes. Range: 400 to 1500 Default: 1400 Defaults Not configured Command Modes CONFIGURATION Command History Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module Usage You can configure up to two sFlow collectors (IPv4). If two collectors are configured, traffic samples Information are sent to both. The sFlow agent address is carried in a field in SFlow packets and is used by the collector to identify the sFlow agent. 572 | sFlow