Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 499
network, offset-list
View all Dell Force10 MXL Blade manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 499 highlights
Parameters ip-address Enter the IP address, in dotted decimal format, of a router with which to exchange information. Defaults Not configured. Command Modes ROUTER RIP Command History Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module Usage Information When a neighbor router is identified, unicast data exchanges occur. Multiple neighbor routers are possible. Use the passive-interface command in conjunction with the neighbor command to ensure that only specific interfaces are receiving and sending data. Related Commands passive-interface Sets the interface to only listen to RIP broadcasts. network Enable RIP for a specified network. Use this command to enable RIP on all networks connected to the switch. Syntax network ip-address To disable RIP for a network, use the no network ip-address command. Parameter ip-address Specify an IP network address in dotted decimal format. You cannot specify a subnet. Defaults No RIP network is configured. Command Modes ROUTER RIP Command History Usage Information Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module You can enable an unlimited number of RIP networks. RIP operates over interfaces configured with any address specified by the network command. offset-list Specify a number to add to the incoming or outgoing route metrics learned via RIP. Syntax offset-list prefix-list-name {in | out} offset [interface] To delete an offset list, use the no offset-list prefix-list-name {in | out} offset [interface] command. Routing Information Protocol (RIP) | 499