Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 649
enable, show running-config uplink-state-group, no enable
View all Dell Force10 MXL Blade manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 649 highlights
Command History Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module Usage Information When one upstream interface in an uplink-state group goes down, a user-configurable number of downstream interfaces in an uplink-state group are put into a link-down state with an UFD-Disabled error message. If all upstream interfaces in an uplink-state group go down, all downstream interfaces in the same uplink-state group are put into a link-down state. Related Commands downstream upstream uplink-state-group Assigns a port or port-channel to the uplink-state group as a downstream interface. Assigns a port or port-channel to the uplink-state group as an upstream interface. Creates an uplink-state group and enable the tracking of upstream links. enable Syntax Parameters Re-enable upstream-link tracking for an uplink-state group after it has been disabled. enable To disable upstream-link tracking without deleting the uplink-state group, use the no enable command. group-id Enables debugging on the specified uplink-state group. Valid group-id values are 1 to 16. Defaults Upstream-link tracking is automatically enabled in an uplink-state group. Command Modes UPLINK-STATE-GROUP Command History Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module Related Commands uplink-state-group Creates an uplink-state group and enable the tracking of upstream links. show running-config uplink-state-group Display the current configuration of one or more uplink-state groups. Syntax show running-config uplink-state-group [group-id] Parameters group-id Displays the current configuration of all uplink-state groups or a specified group. Valid group-id values are 1 to 16. Defaults none Command Modes EXEC EXEC Privilege Uplink Failure Detection (UFD) | 649