Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 54
reload, IPv4 Command Example
View all Dell Force10 MXL Blade manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 54 highlights
www.dell.com | support.dell.com sweep-interval ointerface Enter the incremental value for sweep size. 1-15308 seconds Enter the outgoing interface for multicast packets. • Enter the IP address in A.B.C.D format • For a Port Channel, enter the keyword port-channel followed by a number: 1-128 • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE followed by the slot/port information. • For a VLAN interface, enter the keyword vlan followed by a number from 1 to 4094. Defaults See parameters above. Command Modes EXEC EXEC Privilege Command History Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module Usage Information When you enter the ping command without specifying an IP address (Extended Ping), you are prompted for a target IP address, a repeat count, a datagram size (up to 1500 bytes), a timeout in seconds, and for Extended Commands. For information on the ICMP message codes that return from a ping command, refer to Appendix , . Figure 4-7. ping (IPv4) Command Example FTOS#ping 172.31.1.255 Type Ctrl-C to abort. Sending 5, 100-byte ICMP Echos to 172.31.1.255, timeout is 2 seconds: Reply to request 1 from 172.31.1.208 0 ms Reply to request 1 from 172.31.1.216 0 ms Reply to request 1 from 172.31.1.205 16 ms : : Reply to request 5 from 172.31.1.209 0 ms Reply to request 5 from 172.31.1.66 0 ms Reply to request 5 from 172.31.1.87 0 ms FTOS# reload Reboot FTOS. Syntax reload Command Modes EXEC Privilege Command History Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module 54 | Control and Monitoring