Dell Force10 MXL Blade MXL 10/40GbE Switch IO Module FTOS Command Line Referen - Page 463
Error: Specified VLANs overlap with existing config., Command, History, Usage, Information, Syntax
View all Dell Force10 MXL Blade manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 463 highlights
Command History Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module Usage Information The dot1p-priority command changes the priority of incoming traffic on the interface. The system places traffic marked with a priority in the correct queue and processes that traffic according to its queue. When you set the priority for a Port Channel, the physical interfaces assigned to the Port Channel are configured with the same value. You cannot assign dot1p-priority command to individual interfaces in a Port Channel. rate police Police the incoming traffic rate on the selected interface. Syntax Parameters rate police [kbps] committed-rate [burst-KB] [peak [kbps] peak-rate [burst-KB]] [vlan vlan-id] kbps committed-rate burst-KB peak peak-rate vlan vlan-id Enter this keyword to specify the rate police in Kilobits per second (Kbps). On MXL Switch make the following value a multiple of 64. The default granularity is Megabits per second (Mbps). Range: 0 to 40000000 (Kbps) Enter a number as the bandwidth in Mbps. Range: 0 to 10000 (OPTIONAL) Enter a number as the burst size in KB. Range: 16 to 200000 Default: 50 (OPTIONAL) Enter the keyword peak followed by a number to specify the peak rate in Mbps. Range: 0 to 10000 (OPTIONAL) Enter the keyword vlan followed by a VLAN ID to police traffic to those specific VLANs. Range: 1 to 4094 Defaults Granularity for commit ed-rate and peak-rate is Mbps unless the kbps option is used. Command Mode INTERFACE Command History Usage Information Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module Note: Per Port rate police is supported for Layer 2 tagged and untagged switched traffic and for Layer 3 traffic. Per VLAN rate police is supported on only tagged ports with Layer 2 switched traffic. On one interface, you can configure the rate police command for a VLAN or you can configure the rate police command for an interface. For each physical interface, you can configure three rate police commands specifying different VLANS. After configuring VLANs in the rate police command, if this error message appears: %Error: Specified VLANs overlap with existing config. Quality of Service (QoS) | 463