Netgear GSM7252PS ProSafe Managed Switch Web Management User Manual - Page 135

ProSafe® Gigabit L3 Managed Stackable Switches Software Administration Manual VLAN Configuration To display the VLAN Configuration page, click Switching VLAN  Advanced  VLAN Configuration. Reset Configuration - If you select this button and confirm your selection on the next screen, all VLAN configuration parameters will be reset to their factory default values. Also, all VLANs, except for the default VLAN, will be deleted. The factory default values are: • All ports are assigned to the default VLAN of 1. • All ports are configured with a PVID of 1. • All ports are configured to an Acceptable Frame Types value of Admit All Frames. • All ports are configured with Ingress Filtering disabled. • All ports are configured to transmit only untagged frames. • GVRP is disabled on all ports and all dynamic entries are cleared. Internal VLAN Configuration This page displays the allocation base and the allocation mode of internal VLAN. The internal VLAN is reserved by port-based routing interface and invisible to the end user. Once these internal VLANs are allocated by port-based routing interface, they are cannot be assigned to a routing VLAN interface. 1. Use Internal VLAN Allocation Base to specify the VLAN Allocation Base for the routing interface. The default base of the internal VLAN is 1 to 4093. 2. Use the optional Internal VLAN Allocation Policy field to specify a policy for the internal VLAN allocation. There are two policies supported: ascending and descending. Chapter 3. Configuring Switching Information | 135