Netgear GSM7252PS ProSafe Managed Switch Web Management User Manual - Page 513

ProSafe® Gigabit L3 Managed Stackable Switches Software Administration Manual Captive Portal Global Configuration Using the Captive Portal Global Configuration page, you can control the administrative state of the CP feature and configure global settings that affect all captive portals configured on the switch. To display the Captive Portal Global Configuration page, click Security  Control> Captive Portal  CP Global Configuration. 1. Use Admin Mode to enable or disable Captive Portal feature. By default, the Captive Portal feature is disabled. 2. Use Additional HTTP Port to configure an additional port for HTTP traffic (HTTP traffic uses port 80), but you can configure an additional port for HTTP traffic. Enter a port number between 0-65535 (excluding port 80). Enter 0 to unconfigure the Additional HTTP Port. Default is 0. 3. Use Additional HTTP Secure Port to configure an additional port for HTTP Secure traffic (HTTP Secure traffic uses port 443). Enter a port number between 0-65535 (excluding port 443).Enter 0 to unconfigure the Additional HTTP Secure Port. Default is 0. 4. Use Authentication Timeout to specify the number of seconds to keep the authentication session open with the client. To access the network through a portal, the client must first enter authentication information on an authentication Web page. When the time-out expires, the switch disconnects any active TCP or SSL connection with the client. The valid range is 60 to 600 seconds. Default Authentication Timeout is 300 seconds. Chapter 6. Managing Device Security | 513