Netgear GSM7252PS ProSafe Managed Switch Web Management User Manual - Page 89
PoE Configuration, System, Advanced, System Usage Threshold, Power Management Mode, Auto Reset Mode
UPC - 606449071665
View all Netgear GSM7252PS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 89 highlights
ProSafe® Gigabit L3 Managed Stackable Switches Software Administration Manual Advanced From the Advanced link, you can access the following pages: • PoE Configuration on page 89 • PoE Port Configuration on page 91 PoE Configuration Use the PoE Configuration page to view global PoE power information and to configure PoE SNMP trap settings. To display this page, click System PoE Advanced PoE Configuration. A screen similar to the following displays. 1. Unit - Displays the Current PoE Unit. You can change the PoE Unit by selecting another unit ID listed here. 2. Use System Usage Threshold to set a threshold level at which a trap is sent if consumed power is greater than threshold power. 3. Use Power Management Mode to describe or control the power management algorithm used by the PSE to deliver power to the requesting PDs. "Static" value means that power allocated for each port depends on the type of power threshold configured on the port. "Dynamic" value means that power consumption of each port is measured and calculated in real-time. 4. Use Auto Reset Mode to specify Enable or Disable. When set to "Enable", the PSE port is reset without administrator intervention whenever a fault condition occurs. When set to "Disable", the administrator has to reset the PSE port whenever a fault condition is detected. 5. Use Traps to enable or disable activation of PoE traps by selecting the corresponding check box. The factory default is enabled. Chapter 2. Configuring System Information | 89