Netgear GSM7252PS ProSafe Managed Switch Web Management User Manual - Page 616

ProSafe® Gigabit L3 Managed Stackable Switches Software Administration Manual DiffServ Example Configuration To create a DiffServ Class/Policy and attach it to a switch interface, follow these steps: 1. From the QoS Class Configuration screen, create a new class with the following settings: • Class Name: Class1 • Class Type: All For more information about this screen, see "Class Configuration" on page 5-416. 2. Click the Class1 hyperlink to view the DiffServ Class Configuration screen for this class. 3. Configure the following settings for Class1: • Protocol Type: UDP • Source IP Address: 192.12.1.0 • Source Mask: 255.255.255.0 • Source L4 Port: Other, and enter 4567 as the source port value • Destination IP Address: 192.12.2.0 • Destination Mask: 255.255.255.0 • Destination L4 Port: Other, and enter 4568 as the destination port value For more information about this screen, see "Class Configuration" on page 5-416. 4. Click Apply. 5. From the Policy Configuration screen, create a new policy with the following settings: • Policy Selector: Policy1 • Member Class: Class1 For more information about this screen, see "Policy Configuration" on page 5-420. 6. Click Add to add the new policy. 7. Click the Policy1 hyperlink to view the Policy Class Configuration screen for this policy. 8. Configure the Policy attributes as follows: • Assign Queue: 3 • Policy Attribute: Simple Policy • Color Mode: Color Blind • Committed Rate: 1000000 Kbps • Committed Burst Size: 128 KB • Confirm Action: Send • Violate Action: Drop For more information about this screen, see "Policy Configuration" on page 5-420. 9. From the Service Configuration screen, select the check box next to interfaces g7 and g8 to attach the policy to these interfaces, and then click Apply (See "Service Interface Configuration" on page 5-424). 616 | Appendix B. Configuration Examples