Netgear GSM7252PS ProSafe Managed Switch Web Management User Manual - Page 543
To add the selected ACL to a port or LAG, click the box directly below the port or LAG
UPC - 606449071665
View all Netgear GSM7252PS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 543 highlights
ProSafe® Gigabit L3 Managed Stackable Switches Software Administration Manual To configure IP ACL interface bindings: 1. Select an existing IP ACL from the ACL ID menu. The packet filtering direction for ACL is Inbound, which means the IP ACL rules are applied to traffic entering the port. 2. Specify an optional sequence number to indicate the order of this access list relative to other access lists already assigned to this interface and direction. A low number indicates high precedence order. If a sequence number is already in use for this interface and direction, the specified access list replaces the currently attached access list using that sequence number. If the sequence number is not specified by the user, a sequence number that is one greater than the highest sequence number currently in use for this interface and direction will be used. The valid range is 1-4294967295. 3. Click the appropriate orange bar to expose the available ports or LAGs. The Port Selection Table specifies list of all available valid interfaces for ACL mapping. All non-routing physical interfaces and interfaces participating in LAGs are listed. • To add the selected ACL to a port or LAG, click the box directly below the port or LAG number so that an X appears in the box. • To remove the selected ACL from a port or LAG, click the box directly below the port or LAG number to clear the selection. An X in the box indicates that the ACL is applied to the interface. 4. Click Cancel to cancel the configuration on the screen and reset the data on the screen to the latest value of the switch. 5. Click Apply to save any changes to the running configuration. Table 6-109. Field Interface Direction ACL Type ACL ID/Name Sequence Number Description Displays selected interface. Displays selected packet filtering direction for ACL. Displays the type of ACL assigned to selected interface and direction. Displays the ACL Number (in the case of IP ACL) or ACL Name (in the case of named IP ACL and IPv6 ACL) identifying the ACL assigned to selected interface and direction. Displays the Sequence Number signifying the order of specified ACL relative to other ACLs assigned to selected interface and direction. Chapter 6. Managing Device Security | 543