Netgear GSM7252PS ProSafe Managed Switch Web Management User Manual - Page 98

ProSafe® Gigabit L3 Managed Stackable Switches Software Administration Manual To configure the trap flags: 1. Use Authentication to enable or disable activation of authentication failure traps by selecting the corresponding radio button. The factory default is enabled. 2. Use Link Up/Down to enable or disable activation of link status traps by selecting the corresponding radio button. The factory default is enabled. 3. Use Multiple Users to enable or disable activation of multiple user traps by selecting the corresponding radio button. The factory default is enabled. This trap is triggered when the same user ID is logged into the switch more than once at the same time (either via telnet or the serial port). 4. Use Spanning Tree to enable or disable activation of spanning tree traps by selecting the corresponding radio button. The factory default is enabled. 5. Use ACL to enable or disable activation of ACL traps by selecting the corresponding radio button. The factory default is disabled. 6. Use DVMRP to enable or disable activation of DVMRP traps by selecting the corresponding radio button. The factory default is disabled. 7. Use PIM to enable or disable activation of spanning tree traps by selecting the corresponding radio button. The factory default is disabled. 8. Use OSPF to enable or disable activation of OSPF traps by selecting the corresponding radio button. The factory default is enabled. This field can be configured only if the OSPF admin mode is enabled. 9. Click CANCEL to cancel the configuration on the screen. Resets the data on the screen to the latest value of the switch. 10. Click APPLY to send the updated configuration to the switch. Configuration changes take effect immediately. 98 | Chapter 2. Configuring System Information