Netgear GSM7252PS ProSafe Managed Switch Web Management User Manual - Page 573

ProSafe® Gigabit L3 Managed Stackable Switches Software Administration Manual To configure Port Mirroring: 1. Select the check box next to a port to configure it as a source port. • Mode - Specifies the Mode for mirroring. By default Mode is disabled. 2. Use Source Port to specify the configured port(s) as mirrored port(s). Traffic of the configured port(s) is sent to the probe port. 3. In the Destination Port field, specify the port to which port traffic is be copied. Use the unit/slot/port format to specify the port. You can configure only one destination port on the system. Acts as a probe port and will receive all the traffic from configured mirrored port(s). Default value is blank. 4. From the Session Mode menu, select the mode for port mirroring on the selected port: • Enable - Multiple Port Mirroring is active on the selected port. • Disable - Port mirroring is not active on the selected port, but the mirroring information is retained. 5. Direction - Specifies the direction of the Traffic to be mirrored from the configured mirrored port(s). Default value is Tx and Rx. 6. Click Apply to apply the settings to the system. If the port is configured as a source port, the Mirroring Port field value is Mirrored. 7. To delete a mirrored port, select the check box next to the mirrored port, and then click Delete. 8. Click Cancel to cancel the configuration on the screen and reset the data on the screen to the latest value of the switch. Table 7-118. Field Mirroring Port Description Indicates the port to be in a mirrored state. sFlow From the sFlow link under the Monitoring tab, you can access the following pages: • Basic on page 573 • Advanced on page 575 Basic From the Basic link, you can access the following pages: • sFlow Agent on page 573 sFlow Agent To display the sFlow Agent page, click Monitoring sFlow  Basic  sFlow Agent. Chapter 7. Monitoring the System | 573